Rapid Service Bulletin: svs_ 003  3/2/97

Replacement of die and cutter plate adjuster blocks.

	Due to the short service life of the tapped holes in the heater 
blocks a new design of adjustment block has been implemented. This new 
block is a direct replacement on all machine types.

	To replace the old blocks remove the mounting screw and the block 
will come off.
Screw the new block in place on the die or cutter plate with its screw head
facing out. Insert the hexagon head blanking screw in the old hole. The 
head sits against  the face of the heater block.
	The new system allows you to replace the adjustment screw when 
neccesary and is much easier to use. Another advantage is the die or 
cutter plates are able to be removed and replaced without losing position 
on the job. 

file : manuals svs_blt  svs_003